Vitek VT-3528 BK - Manual (Page 3)

ENGLISH
3
RADIOCLOCK
1. Mode set button “MODE”.
2. Alarm set button «АL».
3. Alarm 1 buzzer/radio select button «АL 1».
4. Alarm 2 buzzer/radio select button «АL 2».
5. Thermometer unit (“C/F”) select button
(C°/F°).
6. Infrared sensor.
7. Navigation button « ».
8. Navigation button « ».
9. Power (radio) on/off (alarm off) button
«ON/OFF».
10. Alarm repeat/timer on button «SNOOZE/
SLEEP».
11. Display.
12. Dial scale and pointer.
13. Audio in jack.
14. Volume control.
15. Wave band control.
16. Tuning control.
17. Reset button «RESET».
18. Temperature sensor (indoor)
19. AC power cord.
20. FM antenna wire.
21. Label.
22. Battery compartment.
23. Speaker.
24. Minute button for projection unit «M».
25. Hour button for projection unit «H».
26. Time set button for projection unit.
27. Focus adjustment for projection unit.
28. Projection unit ON/OFF button.
29. Projection unit.
30. Auto display brightness switching button.
Power connection
Plug AC power cord to outlet AC source. The
unit is equipped with the battery back up
system too. It requires 3 x 3Volt CR 2025 flat
lithium batteries (not included). Insert the
battery in the battery compartment, making
certain that the positive and negative (+and-)
battery terminals are attached to correspond
terminals on the plate in the battery compart-
ment. If an AC power failure occurs, the clock
automatically switches to the battery power
supply. The clock and the timer memory con-
tinue running. When the AC power resumes,
the clock switches back to AC again.
Getting started
Connect the appliance to the outlet AC source.
Press the “RESET” button (17) located on the
back panel of the unit.
- The unit will display full segment, then it will
enter the normal mode.
1. Time and calendar setting
А. Setting time and calendar:
- Press «MODE» button (1) and keep depress
over 2-3 seconds to enter setup mode,
press «MODE» button (1) to change the
mode cycle as follows:
Normal — Year — Month — Day — 12/24H.
— RTC Hour — RTC Min — Normal.
Actions (during data adjustment):
- Keep depressed button
over 2
seconds to adjust data backward.
- Keep depressed button over 2
seconds to adjust data forward.
a. Year set mode.
Time range: 2006г. – 2099г.
Display show year set mode.
b. Month set mode.
Display show month set mode.
3
3528IM.indd 3 3528IM.indd 3 24.11.2006 15:25:01 24.11.2006 15:25:01