Power-Sonic SAFETY DATA SHEET Power Sport Series Batteries - Manual (Page 4)

Power-Sonic MSDS Page 4 of 6
Continued on next page
Section 7 - P recautions for Safe Handling and Use
Steps to be Taken in Case Material is Released or Spilled
There is no release of material unless the case is damaged or battery is misused/overcharged. If release occurs stop flow of
material, contain/absorb all spills with dry sand, earth, or vermiculite. Do not use combustible materials. Neutralize spilled
material with soda ash, sodium bicarbonate, lime, etc. Wear acid-resistant clothing, boots, gloves, and face shield. Dispose of
as hazardous waste. Do NOT discharge acid to sewer.
Waste Disposal Method
Spent Batteries
-
send to secondary lead smelter for recycling. Follow applicable federal, state and local regulations
Neutralize as in preceding step. Collect neutralized material in sealed container and handle as hazardous waste as applicable.
A copy of this MSDS must be supplied to any scrap dealer or secondary lead smelter with the battery.
Precautions to be Taken in Handling and Storing
Store batteries in a cool, dry, well ventilated area that are separated from incompatible materials and any activities which
may generate flames, sparks, or heat. Keep all metallic articles that could contact the negative and positive terminals on a
battery and create a short circuit condition.
Electrical Safety
Due to the battery’s low internal resistance and high power density, high levels of short circuit current can be developed
across the battery terminals. Do not rest tools or cables on the battery. Use insulated tools only. Follow all installation
instructions and diagrams when installing or maintaining battery systems.
Fiberglass Separator
Fiberglass is an irritant to the upper respiratory tract, skin and eyes. For exposure up to 10F°/ use MSA Comfoll with type H
filter. Above 10°F use Ultra Twin with type H filter. This product is not considered carcinogenic by NTP or OSHA.
Section 8 - Control Measures
Respiratory Protection
None required under normal conditions. If battery is overcharged and concentrations of sulfuric acid are known to exceed PEL
use NIOSH or MSH approved respiratory protection.
Engineering Controls
Store and handle batteries in a well ventilated area. If mechanical ventilation is used, components must be acid resistant
Protective Gloves
None needed under normal conditions. If battery case is
damaged use rubber or plastic elbow length gauntlets
Eye Protection
None needed under normal conditions. If handling damaged or
broken batteries use chemical splash goggles or face shield
Other Protective Clothing or Equipment
None needed under normal conditions. In case of damaged or broken battery use an acid resistant apron. Under severe
exposure or emergency conditions wear acid resistant clothing.
Work Hygienic Practices
Handle batteries carefully to avoid damaging the case. Do not allow metallic articles to contact the battery terminals during
handling. Avoid contact with the internal components of the battery.