Spicer Tandem Drive Axles Service Manual S400 - Manual (Page 12)

Bolt
(100-120 Lb-Ft)
(136-163 N-m)
INTER-AXLE DIFFERENTIAL DISASSEMBLY
FFFFFigur igur igur igur igure 4 e 4 e 4 e 4 e 4
Removal slot
Removal slot
1. Remove intermediate case to carrier bolts. Use
removal slots to seperate inter-axle differential
case from carrier.
See Figure 4.
2. With inter-axle differential assembly removed,
remove four bolts and washers of shift cylinder.
3. Remove shift cylinder cap and piston.
NOTE: It may be necessary to tap piston lightly with
soft mallet to remove.
4. Remove shift cylinder shaft.
5. Remove flanged hex nut.
Shift Fork
Drain Plug
(35-45 Lb-Ft)
(47-61 N-m)
Bolt
(160-180 Lb-Ft)
(217-244 N-m)
Fill Plug
(35-45 Lb-Ft)
(47-61 N-m)
Inter-axle Differential Case
Bearing Cup
Bearing Cone
Inter-axle Differential Side Gear
Inter-axle Differential Assembly
Helical Drive Gear
Needle Bearing
Needle Bearing
Thrust Washer Assembly
Lube Retainer
Washer
Bolt
(20-25 Lb-Ft)
(27-34 N-m)
Input Shaft
Clutch Collar
Bearing Cone
Bearing Cup
Shim (Selective)
Spacer
Input Shaft
Bearing Retainer
Seal
Input Yoke Assembly
Flanged Hex Nut
(900-1,200 Lb-Ft)
(1,220-1,627 N-m)
Shift Cover O-ring
Piston Assembly
Shift Cover
Washer
Shift Cover Bolt
(15 - 20 Lb-Ft)
(20-27 N-m)
Shift Shaft
Spring
10