Spicer Single Drive Axles Service Manual: S170, S190, S590 - Manual (Page 27)

23
Wheel Differential
Wheel Differential Assembly - Forward Carrier Assembly
To prevent bearing damage, use suitable sleeve that only
contacts the inner race of the cone. A used bearing race
would be a suitable tool. This tool should have a slit cut if
the ID is the same as the flange OD.
1. Press the new bearing cone on the plain half and
flange half bearing boss using the proper press
sleeve or bearing installation tool.
2. Place the plain half side of the differential case on a
malleable surface.
3. Install the side gear. Apply a thin coat of oil to the
mating surfaces of the side gear and plain half.
5. Install the flange half side gear. Apply a thin coat of
oil to the mating surfaces.
6. Install the ring gear. Align the capscrew holes.
IMPORTANT
4. Assemble the side pinions onto the wheel differential
spider. Apply a thin coat of oil to the mating surfaces
of the side pinion and differential spider. Install the
wheel differential nest on top of the side gear.
1
1 - Match spacing of holes on each side of
spider slots