Spicer Drive Axles Service Manual Single Axles 2-Speed & Double Reduction - Manual (Page 18)

Assemble Wheel Differential
NOTE: Lubricate internal parts with gear
lube during reassembly.
1. Press bearing cones on support cases
(see illustration).
CAUTION: To prevent bearing cone
damage, use suitable sleeve that only
contacts the inner race of the cone.
2. Position high-speed clutch plate with
chamfered end of the clutch teeth toward
idler pinions. Press clutch plate on case
(see illustrations below).
CLUTCH PLATE
r 1
I
I
Clutch
.:. .:.
. . . . . . . . . . . . . . . . .
INSTALLATION
CAUTION: It is important that the ends of the dowel pins are recessed 1/8" below surface of
the clutch plate. If pins extend beyond plate surface, press pins to proper depth. Don't press
them in too far.
18
Section 3
REMOVAL / DISASSEMBLY
Drive Axle
Overhaul