Disassemble wheel differential – Spicer Tandem Drive Axle Dual Range & Double Planetary 34,000-45,000 lbs User Manual
Page 47
Advertising
Disassemble Wheel Differential
\
1.
Remove nuts and bolts fasten-
ing ring gear and support cases.
3.
Remove ring gear.
NOTE:
A soft-faced hammer or
mallet may be required to dislodge
gear from its mounting.
4.
To remove differential assembly,
place support case assembly on a
bench or on the floor. Position case
on its side, then slowly roll the
case and slide differential assembly
out of the case.
2.
Remove small support case and
thrust washer.
5.
Remove thrust washer from
support case.
6.
Invert differential assembly to
remove idler pins, then remove
idler pinions.
7.
Punch mark differential cases
for correct location in reassembly.
Remove cap screws and separate
case halves.
47
Advertising