Spicer Wheel Differential Bearing Replacement Process User Manual
Page 8
35. Torque carrier to housing capscrews to the chart below.
Axle Location
Dana Kit Part Number
Fastener Type
N.m
Ibs-ft
Forward
512896
Capscrew and Nut
338 - 393
250 - 290
Rear - Rear
512897
Capscrew and Nut
338 - 393
250 - 290
36. Clean axle shaft flanges and wheel hub surfaces and install new axle shaft gasket.
37. Reinstall the axle shaft, washers and nuts, torque to spec.
38.
Reconnect IAD shift cylinder and/or wheel diff. lock air line.
39.
Reinstall the driveline.
40. Remove fill plug from housing cover and refill the housing using the same lubricant that was removed. If needed,
add lube and fill until level with the bottom of the fill hole.
For spec’ing or service assistance, call 1-800-
24 hours a day, 7 days a week.
Or visit our web site at:
http://www.
VSLFHUSDUWV.com
Dana Corporation
SHAIS183A
Copyright Dana Corporation, 2008
Heavy Vehicle Technologies and Systems Service
June 2008
All Rights Reserved.
P.O. Box
Printed in U.S.A.
www.dana.com
Toledo, Ohio 43697-0321