Spicer Wheel Differential Bearing Replacement Process User Manual
Page 7
29. It is important that the stake depth is deep enough to enter the machined slot in the carrier housing. There will be
a 1/6” space between the adjuster ring and carrier housing on the plain half side. You will see some bending of
the retaining ring.
30. The carrier assembly can now be reinstalled into the drive axle housing.
Note: Before installing new fastener hardware or the carrier assembly, inspect the axle housing visually for
cracks, nicks or burrs on all machined surfaces. It is important that all surfaces are cleaned properly. Stud
should only to be replaced if the stud came out with the nut at the time of disassembly.
31. Use a wire wheel to remove any paint, old sealant or oil from the housing and carrier mounting surfaces. Wipe
surfaces down with cleaning solvent to remove any residual oil or dirt.
32. Apply a 1/8” bead of Loctite 5699 Ultra Grey or Dow Corning 3-0100 Automotive Sealant to the housing surface,
it’s important to apply the sealant around (make a loop) all of the threaded bolt holes.
Important Note : Do not spread or smooth-out RTV once applied. RTV will set in 20 Minutes. Install carrier
before RTV sets or reapply.
33. Install carrier into housing.
34. Install new fasteners and run them down with an impact gun in a crisscross pattern.
1/6” Gap
Machined
Slot
Ring
Deflection