Spicer DS462 User Manual
Page 4
Ground Connection
11. Important: The first weld pass must be centered over the fit-up line and penetrate the failed area. Remove
all slag. The first pass must cool before the second pass can be applied.
First Pass
Housing
First Weld Pass
(Centered over
fit-up line)
Cover
12. Second Pass Cover Weld – Remember, do not start or stop at the 12:00 position. The second pass will be
placed slightly above the initial pass. See drawing below. When making the second pass the weld direction
should be reversed. When using an Arc welder you may have to start the weld at the 1:00 position so that you
do not run out of electrode at the 12:00 position. You can then go back and fill in the ends of the weld area.
When the second pass cools, apply the third weld pass as show on the diagram below.
Second Weld Pass
Housing
Cover
Second Pass Cover
4
This bulletin contains product information.
Dana Corporation is not committed or liable for canvassing existing product.