Spicer Steer and Drive Wheel Ends Service Manual - Manual (Page 2)

General Information
General Information
The description and specifications contained in this service publication are current at the time of printing.
Dana Corporation reserves the right to discontinue or to modify its models and/or procedures and to change specifications at any
time without notice.
Any reference to brand names in this publication is made simply as an example of the types of tools and materials recommended
for use and should not be considered an endorsement. Equivalents, if available, may be used.
Important
Always use genuine Spicer replacement parts.
Spicer recommends following all manufacturers recommendations for the proper handling and disposal of lubricants and sol-
vents. For further information contact the supplier of lubricants and solvents.
Welding or machining on any axle component is prohibited unless noted otherwise in this document or other Spicer service
literature.
Every effort has been made to ensure the accuracy of all information in this guide. However, Spicer makes no expressed or
implied warranty or representation based on the enclosed information.
This symbol is used throughout this manual to
call attention to procedures where carelessness
of failure to follow specific instructions may
result in personal injury and/or component
damage.
Departure from the instructions, choice of tools,
materials and recommended parts mentioned in
this publication may jeopardize the personal
safety of the service technician or vehicle
operator.
Failure to follow indicated
procedures creates a high risk of personal
injury to the servicing technician.
Failure to follow indicated
procedures may cause component
damage of malfunction.
Highly recommended procedures for
proper service of this unit.
NOTE: Additional service information not
covered in the service procedures.
CAUTION
IMPORTANT
WARNING
CAUTION