Spicer Jeep Grand Cherokee WJ 44-4 SERVICE MANUAL - Manual (Page 21)

21
X5001-CVSP
During rebuilding, it is critical
that the plates and discs are measured accurately.
When measuring, it is important that the new stack
height is not less than the original stack height.
Spicer offers service kits with the pre-measured
stack included. (Figure 66) Be careful not to mix
stacks when rebuilding the case.
13. Place a disc on top of the bellville washer, then
a plate on the disc, until there are four plates
and four discs on the side gear (Figure 68).
When the process is finished, a plate should be
on the top of the stack.
14. Place one clip over each side of the disc and
plate stack to hold the plates together (Figure
69). Repeat this procedure for the other side
gear.
12. To put the first disc and plate stack together,
use a side gear with the teeth facing down. Put
the Belleville washer over the hub of the side
gear with the convex side contacting the side
gear (the ears facing up) (Figure 67).
A friction modifier must be
placed on all plates and discs at the time of the
assembly. Spicer part number 43161 is recom-
mended.
15. Take the differential case and put it on the
table with the flange side facing up.
Figure 66
Figure 67
Figure 68
Figure 69
CAUTION
CAUTION