Velleman PCGU1000 - Manual (Page 5)

5
Hardware Set-up
(Close all programs before continuing)
LPT connected devices (PCS500/ PCS100 / PCG10 / K8016 / K8031….):
• Connect your device using the supplied cable on a free LPT port
• Start the software after PC-LAB2000se installation (see next page)
USB connected devices:
PCS10 / K8047:
• Connect the PCS10 to a free USB port, a standard windows USB driver
will be used.
(*) For Win98se an USB- HID driver update can be necessary (see CD).
PCSU1000 / PCGU1000:
• Connect your device to a free USB port
• Follow the on screen driver installation procedure.
• If Windows asks for Windows Update, select “not at this time”
• Install the driver from a specific location, then browse on the CD and
select the folder D:\PCSU1000_driver . or D:\PCGU1000_driver* (press “next”)
• If Windows indicate “has not passed Windows logo testing…” select
“Continue Anyway”.
• After finishing, you can check the driver installation in the Device Man-
ager list. Under USB controllers “PCSU1000 oscilloscope” or
“PCGU1000 should appear (only if unit is connected !).
(*) It is possible 2 drivers (USB and COM) must be installed by repeating the above.
For more information see the extended manual on the CD
* Microsoft Windows™ 98SE/ME/2000/NT4/XP/VISTA are registered trademarks
Hardware setup