Velleman PCSGU250 - Manual (Page 6)

6
Hardware connection Hardware connection Hardware connection Hardware connection
Note Note Note Note:::: ---- At first time power At first time power At first time power At first time power----up, the oscilloscope will calibrate itself automatically. up, the oscilloscope will calibrate itself automatically. up, the oscilloscope will calibrate itself automatically. up, the oscilloscope will calibrate itself automatically.
---- The The The The actual screen actual screen actual screen actual screenssss can differ from the one shown in this manual can differ from the one shown in this manual can differ from the one shown in this manual can differ from the one shown in this manual. . . .
Hardware Set Hardware Set Hardware Set Hardware Set----up up up up (Close all programs before continuing) (Close all programs before continuing) (Close all programs before continuing) (Close all programs before continuing)
USB driver install: USB driver install: USB driver install: USB driver install:
• Connect your PCSGU250 unit to a free USB port
• Follow the on screen driver installation procedure.
• If Windows asks for Windows Update, select “not at this time”
• Install the driver from a specific location, then browse on the CD and select the
folder D:\PCSGU250Driver
D:\PCSGU250Driver D:\PCSGU250Driver D:\PCSGU250Driver. (press “next”)
• If Windows indicate “has not passed Windows logo testing…” select “Continue
Anyway”.
• After finishing, you can check the driver installation in the Device Manager list.
• It is possible that the PC asks to “restart” for proper installation
Note: Note: Note: Note: In case of malfunction, remove the USB driver in the control panel and
install the D:\PCSGU250Driver\PCSGU250Driver_WinUSB after reconnecting the
device.
Starting
Starting Starting Starting the software : the software : the software : the software :
Locate the Pc Pc Pc Pc----Lab2000LT Lab2000LT Lab2000LT Lab2000LT software shortcuts (programs.. Pc-Lab2000LT …)
Click the
icon to start the main program. “ loading, please wait loading, please wait loading, please wait loading, please wait ” should ap-
pear. Then the power LED goes ON on the unit. (*)
The main program automatically launches the Oscilloscope and generator
screen, which is shown on the next pages. Should you receive an error (ex. If no
unit is detected), disconnect and reconnect the USB cable and try again or, if you
want to access the demo mode (no unit is needed) :
- Click the Options menu, and select ‘ Hardware Setup’ > demo mode