V-Tech VT596F_KP Manual - Manual (Page 10)

Input the master code.
(Default: [ ]+[#] )
(red)
ON
(blue)
OFF
Beep+, Beep
(red)
ON
(blue)
ON
Beep+, Beep
(red)
ON
(blue)
ON
Beep+, Beep
(red)
ON
(blue)
ON
Beep+, Beep
(red)
ON
(blue)
OFF
Beep+
(red)
ON
(blue)
OFF
Beep+
(red)
ON
(blue)
OFF
Beep+
Inputting of code (ex.: 2011)
1~12 digits
14.Setting the code
for user
13.Setting the code
forTemporary2
Input the setting code. Input the setting code.
12.Setting the code
forTemporary1
18+# 19+#
21+#
2011+#
Inputting of code (ex.: 1006)
1~12 digits
1006+#
Inputting of code (ex.: 2011)
1~12 digits
2011+#
Input the setting code.
(ex.:21)
20~99
- When the “ cancel” key is pressed, the LED lights off, the buzzer beeps, and the system exits the setting mode
-
When there isn’t any operation in 10s, the LED lights off, the buzzer beeps, and the system exits the setting mode
(red)
OFF
(blue)
OFF
Beep, Beep+
*
- When input the correct temporary password to release the door,
the system will clear the temporary password after 60 seconds
automatically.But you should know that the password is valid within
60 seconds after inputing the correct temporary password
- If the password length exceeds 12 digits, the system will sent out
the sound of “beep,beep,beep,beep”,and the digitals you input
before will be cleared at the same time.
- The temporary code can not be set the same as the master code
and user code.
- The user code is used to release
the lock,80 group passwords can
be supported.
- If the password length exceeds
12 digits, the system will sent out
the sound of “beep,beep,beep,beep”,
and the digitals you input before
will be cleared at the same time.
- The user code can not be set the
same as the master code and
temporary code.
10.Interference resistant
grade setting
(Default 2)
(blue)
ON
Beep+, Beep
(blue)
OFF
Beep+
Input the setting code.
09+#
Inputting of code (ex.: 3)
range:0~5
3+#
Setting items
Step 1
Step 2
Step 3
Step 1
Step 2
Step 3
Step 1
Step 2
Step 3
Step 1
Step 2
Step 3
- The larger you set the interference
resistant grade,the stronger it will be,
but the sensitivity of the keypad will
be more lower.
- The interference resistant grade
setting also will activatethe keypad
checking.
-9-