Battery installation, Telephone base and charger installation – VTech DS6511_-15-16-2-3-4A Abridged manual User Manual

Page 2

Advertising
background image

2

Battery installation

Install the battery as shown below.

Slide the battery compartment

cover towards the center of the

handset until it clicks into place.

3.

Place the handset in the telephone

base or charger to charge.

4.

CHARGE light

remains on

when charging.

Plug the battery connector

securely into the socket.

.

Place the battery with the label

THIS SIDE UP facing up and the wires

inside the battery compartment.

2.

If the handset will not be used for a long time, disconnect and remove the battery to

prevent possible leakage.

Telephone base and charger installation

Install the telephone base and charger as shown below.

Use only the power adapters and batteries supplied with this product. To order a

replacement, visit our website at www.vtechphones.com or call  (800) 595-95.

In Canada, go to www.vtechcanada.com or call  (800) 267-7377.
Even if you do not subscribe to any conventional telephone service, you can still

use the cell line alone without plugging in a telephone line cord.
If you subscribe to telephone service from a cable company or a VoIP service

provider, contact your cable/VoIP service provider for more information.

Telephone base

Charger

Telephone base

power adapter

Electrical outlet

not controlled by

a wall switch

Electrical outlet

not controlled

by a wall switch

Telephone wall jack

Charger adapter

Telephone

line cord

A DSL filter (not included) is

required if you have DSL

high-speed Internet service.
The DSL filter must be

plugged into the telephone

wall jack.

IMPORTANT:
Check for a dial tone by pressing

/HOME. If you hear a dial tone, the installation

is successful.
If you do not hear a dial tone:

Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service to

digital service from a cable company or a VoIP service provider, the telephone

line may need to be rewired to allow all existing telephone jacks to work.

Contact your cable/VoIP service provider for more information.


Advertising