VTech DS6751_-2-3 Abridged manual - Manual (Page 3)

3
Get started
Connect the telephone base and handset charger
Use only the power adapters and batteries supplied with this product.
To order replacements, visit our website at www.vtechphones.com or call
1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call
1 (800) 267-7377.
Even if you do not subscribe to any conventional telephone service, you can still
use the cell line alone without plugging in a telephone line cord.
If you subscribe to telephone service from a cable company or a VoIP service
provider, contact your cable/VoIP service provider for more information.
•
•
•
Install battery
 2 3
Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES. NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Ba
tt er y Pa
ck / Bloc-piles
:
(2.4V Ni-MH)
W ARNING /
AV
ERTISSEMENT
:
DO NO
T BURN OR PUNC
TURE BA
TT
ERIES
.
NE
PA
S INCINÉRER OU PERCER LES PILES.
Made in China /
Fa
briqué en chine
TH
IS
S
ID
E U
P
/ C
E
CÔ
TÉ
V
ER
S LE
H
AU
T
Plug!
Charge your phone
Charge for at least 30 minutes before initial settings.
Charge for 11 hours before initial use.
IMPORTANT:
Press
/HOME to check for a dial tone. If you hear a dial tone, the installation is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service to digital service
from a cable company or a VoIP service provider, the telephone line may need to be
rewired to allow all existing telephone jacks to work. Contact your cable/VoIP service
provider for more information.
•
•
Light on!
The battery icon
Animates when the battery is charging.
Flashes when the battery is low and
needs charging.
Becomes solid when the battery is
fully charged.
•
•
•
4
TEL. LINE
Use Only
Supplied Adapter
DC 6V
DSL filter
Plug!
Click!
Plug!
Plug!
Click!
Configure your phone
Set date and time
Press MENU when the telephone base/handset is not in use.
Scroll to Set date/time, then press SELECT.
Enter the month ( MM), date (DD) and year (YY), then press SELECT.
Enter the hour ( HH) and minute (MM). Then scroll to AM or PM.
Press SELECT.
If you subscribe to caller ID service, the day, month and time are set automatically
with each incoming call.
.
2.
3.
4.
5.
Click!