VEGA VEGACOM 557 Profibus DP User Manual
Operating instructions, Vegacom 557 profibus dp
Advertising
Table of contents
Document Outline
- Contents
- Safety information
- Note Ex area
- 1 Product description
- 1.1 Application
- 1.2 Configuration
- 1.3 Functions
- 1.4 Type plate and order code
- 1.5 Technical data
- 1.6 Dimensions
- 1.7 Indicating and adjustment elements
- 2 Mounting and electrical connection
- 2.1 Mounting instructions
- 2.2 Mounting in carrier and housing
- 2.3 Wiring plan VEGACOM 557
- 2.4 Mounting and installation instructions with VEGACOM 557AP
- 3 Switch settings on VEGACOM 557
- 3.1 Adjustment of the PC interface
- 3.2 Adjustment of the Profibus DP interface
- 4 Measurement loop in VEGAMET/VEGALOG
- 4.1 PC/DCS output
- 5 Transfer of measured value
- 5.1 Format for transfer of measured value
- 6 Operating mode VEGACOM 557
- 6.1 Mode 50E2A
- 6.2 Mode 6E6A
- 6.3 Selection of the operating mode
- 7 Data image in VEGACOM 557
- 7.1 Image of measured value when connecting to DISBUS
- 7.2 Measured value image when connecting to LOGBUS
- 7.3 Overview of the operating modes and control commands
- 8 Setup
- 8.1 Setup check list
- 8.2 Setup SIEMENS S7 automation system
- 8.3 Setup SIEMENS S5 with IM308C
- 9 Parameter adjustment via Profibus DP
- 10 Utility diskette for VEGACOM 557 Profibus DP
- Supplem. A
- Supplement B
- Supplement C
- 1 General information on PROFIBUS
- 2 Special information on Profibus DP
- 3 Short description of the interface RS 485