VEGA VEGATOR 536 Ex - Manual (Page 6)

6 VEGATOR 536 Ex
Mounting
Mounting single housing
You can either screw the socket directly to
your mounting plate or plug on a carrier rail
(TS 35 x 7,5 acc. to EN 50 022 or TS 32 acc.
to EN 50 035). Connect the terminals of the
basic plate according to the connection plans
on the following pages. For further information
concerning mounting, see the operation in-
structions of the housing.
Transparent cover
The front plate of VEGATOR can be provided
with a lockable transparent cover to protect
the instrument against unauthorised adjust-
ment. The cover is attached to the instrument.
2 Mounting
VEGATOR can be either mounted with a
module in a carrier BGT 596 or in a single
housing type 505.
Module (33)
for VEGATOR 536
Multipoint connector DIN 41 612, series F, 33-
pole (d, b, z) with coded pin and mounting
material for mounting in carrier BGT 596.
Module-Ex (33 Ex)
for VEGATOR 536 Ex
Multipoint connector DIN 41 612, series F, 33-
pole (d, b, z) with coded pin and mounting
material for mounting in carrier BGT 596 Ex.
Single housing
Plastic housing type 505 for single mounting
of signal conditioning instruments with an
instrument width of 5 TE (25,4 mm).
Mounting carrier
Mount the appropriate module (standard or
Ex-version) to your carrier BGT 596. Please
wire the connections of the multiple plug
according to the connection plans on the
following pages.
The multipoint connection is available as
follows:
- Wire-Wrap standard connection
1,0 x 1,0 mm
- Plug connection 2,8 x 0,8 mm
- Termi-Point standard connection
1,6 x 0,8 mm
- Soldering connection
- Screw terminals 2 x 0,5 mm
2
For further information concerning mounting,
please see the operating instructions of the
carrier.