M-AUDIO Lagoon - Manual (Page 26)

Troubleshooting
Problem Advice
Optical output does
not work 1. Check if you connected the cable correctly: You
should see a red light coming out of the optical cable
that comes from the output of your LAGOON card.
2. Check if you chose the correct output format
(S/PDIF or ADAT) in the LAGOON Tools General
page.
3. Check MME Output device settings in the
LAGOON Tools MME page. Maybe No output
device is selected.
4. Check your application software output
configuration. Maybe the LAGOON card is not
selected as output device.
1. Check if you connected the cable correctly: You
should see a red light coming out of the optical cable
that comes from the output of your external
equipment.
2. Check if you chose the correct input format (S/PDIF
or ADAT) in the LAGOON Tools General page.
3. Check MME Input device settings in the LAGOON
Tools MME page. Maybe No input device is
selected.
4. Check your application software input
configuration. Maybe the LAGOON card is not
selected as input device.
1. Check Clock source settings in the LAGOON Tools
General page. You must choose ADAT Sync In.
2. Check if the MIDI Input device is enabled in the
LAGOON Tools MIDI page (only necessary for
Time Code synchronization).
3. Check your application software MIDI input
configuration. Maybe the LAGOON card is not
selected as MIDI input device (only necessary for
Time Code synchronization).
1. Check Clock source settings in the LAGOON Tools
General page. You must not choose ADAT Sync In.
2. Check if the MIDI Input device is enabled in the
LAGOON Tools MIDI page.
3. Check your application software MIDI input
configuration. Maybe the LAGOON card is not
selected as MIDI input device.
Optical input does
not work.
ADAT Sync In does
not work correctly.
MIDI does not work
correctly.
25