Binatone JE-556 - Manual (Page 6)

6
BEFORE USE
Read this instruction carefully.
Remove all packaging materials.
Check whether the voltage shown on the label
of your juice extractor is the same as that of
your home power supply.
Before first using your juice extractor, carefully
wash and dry all parts that will come into con-
tact with food.
Check whether the appliance is assembled correctly (see Assem-
bling section).
INSTRUCTIONS FOR USE
Disassembling
1. Make sure the appliance is switched off and un-
plugged.
2. Open the safety clips (4), remove the top cover
(3) and the separator (6) with the cutter/
strainer (9).
Note: when disassembling the appliance, always remove the
cutter/strainer (9) together with the separator (6).
Assembling
1. Put your juice extractor on a dry clean horizontal surface.
2. Install the separator (6) on the juice extractor casing (10) so that
the side guides of the separators fit into the grooves on the casing.
3. Install the cutter/strainer (9) on top of the separator (6) so that its
connected to the cutter/strainer drive (11) and can rotate freely.
4. Put the top cover (3) of the juice extractor on and close the safety
clips (4).
Note: The juice extractor has a safety device. If the top
cover (3) or safety clips (4) are not locked properly,
the appliance will not function. It will automatically
switch off in case it unlocks in the course of the juice
extractor operation.
5. Place the pulp container (14) under the pulp outlet (8), then place
the juice cup with the foam separator (13) under the separator
spout (6). The foam separator efficiently separates foam from juice.
The extracted juice will be collected in the juice cup (13). Pour the
juice into another cup before serving, so that the foam stays in the
bottom of the juice cup. You may also use any other container of
appropriate size to collect juice instead of the juice cup (13).
6. Install the food tray (2) on top of the food chute (5) to put fruit and
vegetables on it in the course of juice extraction. As the shape of
the food tray (2) exactly matches the shape of the top cover (3),
you can use it as a cover by turning the tray upside down before
placing the appliance for storage.