Binatone JE-556 - Manual (Page 7)

7
ENGLISH
Use
1. Before plugging in the appliance, make sure the juice extractor is
switched off and the safety clips (4) are closed properly.
2. Prepare the products for processing. To ensure efficient opera-
tion, follow the rules below:
– Do not slice products into very small chunks, as this will increase
the waste and make the juice extractor less efficient.
– Do not place more that one chunk at a time in the food chute
(5). Put the next chunk in the food chute (5) only after the pre-
vious one is fully processes and juice stops to come out of the
spout.
3. Switch off the juice extractor using the switch (12).
4. Put a chunk into the food chute (5) and slowly push it with the
pusher (1) to the processing area. Do not push too hard as it will
lead to decrease in the appliance efficiency.
5. When you put fruits and vegetables into the juice extractor, the
appliance drive should be running.
6. If in the course of juice extraction the pulp container (14) gets full,
switch off the juice extractor, remove pulp and reinstall the con-
tainer. To continue juice extraction, switch on the appliance.
7. After you finish extracting the juice, clean the appliance immedi-
ately and dry all its components.
CARE AND CLEANING
1. Unplug the juice extractor and disassemble it.
2. For safety reason do not submerge the appli-
ance casing (10) in water or other liquids, just
wipe it with a clean damp lint free cloth
3. Wash other juice extractor components in
soapy water using a soft sponge. Do not use a
stiff brush or abrasive detergents.
4. Plastic juice extractor components may get stained when you pro-
cess certain types of fruits and vegetables (like carrot, oranges,
beet-root, etc.). To remove stains wipe these components with a
cloth soaked in a water and vinegar solution (2-4 tea spoons of
9% vinegar to a glass of water). Then clean as usual.
5. Treat the cutter/strainer (9) with care to avoid damage. Lack of
proper care may lead to the cutter/strainer becoming damaged.
Follow the rules below:
– The cutter/strainer should be cleaned using a soft brush.
– Do not use detergents containing chloride lime or metal brushes.
– Replace the cutter/strainer if it is showing signs of damage.
HELPFUL HINTS
Make juice from fresh vegetables. Do not process
over-ripe fruit. The juicier the product, the more
juice you get. The juice may contain up to 30%
pulp depending on the product. It is normal to have
pulp content in the juice.
When using over-ripe or soft apples, pears etc.
the pulp content may be higher than usual.