VEGA VEGABAR series 80 - Manual (Page 8)

8
4 Mounting
Electronics module • VEGABAR series 80
45054-EN-131119
ment data processing will not be correct. The result is the output of
incorrect measured values to the signal output.
4.3 Mounting steps
1
Fig. 1: Single chamber housing
1 Position electronics compartment/Electronics module
1
Fig. 2: Double chamber housing
1 Position electronics compartment/Electronics module
Proceed as follows:
1. Switch off power supply
2. Unscrew housing cover of the electronics compartment
3. Remove the terminal blocks according to the operating instruc-
tions manual of the respective sensor
4. Loosen the two holding screws with a screwdriver (Torx size T 10
or slotted screwdriver size 4)
2
1
5 6 7 8 1 2 + ( ) (-)
Fig. 3: Loosening the holding screws
1 Electronics module
2 Screws (2 pcs.)
5. Pull the previous electronics out by using the dismounting tool.