VEGA VEGABAR series 80 - Manual (Page 9)

9
4 Mounting
Electronics module • VEGABAR series 80
45054-EN-131119
Note:
Make sure that the housing is not rotated during the electronics ex-
change. Otherwise the plug may be in a different position later.
6. Insert the new electronics module carefully. Make sure that the
plug is in the correct position.
7. Screw in the two holding screws and tighten them
8. Attach the terminal blocks according to the operating instructions
manual of the respective sensor
9. Screw the housing cover back on
The electronics exchange is now finished.
As a rule, an exchange of electronics must be documented internally
if Ex applications are involved.