Velleman VDPC146 - Manual (Page 5)

VDPC146
V. 02 – 21/10/2013 5 ©Velleman nv
Front panel (image A)
18
STEP Press this button to advance step by step in a
programme. (speed slider should be in the lowest
position: SHOW MODE)
19 AUDIO Press this button to access the audio control mode.
20 HOLD Hold this button to stop the chase.
21 PARK In DOUBLE PRESET, pressing PARK B activates the
maximum value for MASTER B. In SINGLE PRESET,
pressing PARK A activates the maximum value for
MASTER A.
22 REC EXIT Press this button to add or kill a channel. The LED
indicator is lit when the device is in kill mode. Press
an arbitrary flash button to reduce all channel output
levels to zero, with the exception of the selected
channel. This button also deactivates the recording
mode.
23 RECORD Press this button to record a step in a programme.
24 PAGE Select the desired scene or chase on the selected
page (1 – 4).
25 MODE SELECT In the CHASE/SCENES mode, you can press this
button to choose between the DOUBLE PRESET or
SINGLE PRESET mode.
26 DARK For a blackout of all channels, including the ones that
are currently in FULL ON and FLASH mode.
27 ALL REV Reverses the direction of a chase.
28 0% or 0-255 Switches the display from 0-100% to 0-255 and vice
versa.
29 REV ONE Hold this button and press any button of PRESET B.
The selected scene will now chase in reverse.
30 CHASE REV This button enables you to reverse the chase
controlled by the SPEED slider.
31 BEAT REV This button enables you to reverse the chase to the
beat of the music.
Back panel (image B)
1
Power input 12-20Vdc / 500mA
2 MIDI THRU used to transmit MIDI data received on the MIDI IN connector
3 MIDI OUT
4 MIDI IN
5 DMX OUT 3-pin female XLR
6 DMX POLARITY select the polarity of the DMX OUT
7 AUDIO INPUT RCA (cinch) line in 100mV, 1Vp-p
8 REMOTE FULL ON and BLACKOUT can be controlled from a distance using a ¼” stereo jack
(6.35mm)
5.2 Connections
The manufacturer is not responsible for damage caused by improper connections.
•
Connect the supplied adapter with the DC jack and connect the other end with a mains outlet.
• Plug the XLR cable into the device and connect the other end with the first device you wish to control.
• Plug the MIDI cables into the appropriate MIDI sockets.
6. Programming
6.1 Leaving the Recording Mode
1. Hold the RECORD button.
2. Press the REC EXIT button.
3. Release the RECORD button.