Velleman VTTEST18 - Manual (Page 4)

VTTEST18
V. 02 – 05/04/2013 4 ©Velleman nv
1. Place the probe tip on or near the circuit or unit to be tested. The probe
tip lights and you hear a beep to indicate the presence of an AC voltage
from 100 to 600 VAC.
2. To find a break in a hot conductor, trace the wire until the signal stops.
To find a break in a neutral conductor, connect a load between the hot
and neutral, and then trace the wire until the signal stops.
3. Press the on/off button to use the flashlight.
Note that this tool will not detect voltages on armoured cables, or
on cables behind panels, in metallic enclosures, etc.
4. Battery Insertion/Replacement
1. Disconnect the tool from the circuit.
2. Gently lift the pocket clip while pulling the cap.
3. Insert the included batteries or replace the batteries with an exact
equivalent. Respect the polarity.
4. Slide the cap back on the tool to close.
Warning: Do not puncture batteries or throw them in fire as they
may explode. Do not attempt to recharge non-rechargeable
batteries (alkaline). Dispose of batteries in accordance with local
regulations. Keep batteries away from children.
Remove the battery if the device will not be used for a long time. Old
batteries can begin to leak and damage the device.
5. Technical Specifications
standard CAT III 1000 V
voltage range 100-600 VAC
power supply 2 x AAA (LR03C), incl.
dimensions 176 x 26 mm
weight 48 g (with batteries)
IP rating IP20
Use this device with original accessories only. Velleman nv cannot
be held responsible in the event of damage or injury resulting from
(incorrect) use of this device.
For more info concerning this product and the latest version of this
manual, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior
notice.