Velleman VTDESOL3 - Manual (Page 2)

VTDESOL3
V. 01 – 12/06/2013 2 ©Velleman nv
USER MANUAL
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
Always disconnect mains power when device not in use or when servicing or maintenance
activities are performed. Handle the power cord by the plug only.
Indoor use only. Keep this device away from rain, moisture, splashing and dripping
liquids.
Keep this device away from children and unauthorized users.
Caution: device heats up during use.
There are no user-serviceable parts inside the device. Refer to an authorized dealer for
service and/or spare parts.
Use eye protection. Desoldering can produce noxious fumes, so exercise caution.

Do not point the heat gun directly at your skin, as it may cause serious burns.
 Work in a well-ventilated area - solder flux fumes may cause breathing problems and eye irritation.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.

If you are desoldering a printed circuit board: place the board on a flat, dry surface with the component
side faceup. Make sure the board lies perfectly flat. The heat gun can also melt solder on nearby
components you were not planning to remove. If the board is not perfectly flat, these components can get
dislodged from their positions as their solder softens.
 Do not keep the heat gun on and pointed at the components for more than one minute at a time, as the
heat may damage the board and components.
4. Operation
1. Plug the power cord into a power source.
2. Allow the nozzle to warm up for approx. 5 min.
3. Press the plunger [1] until you hear a clicking sound.
4. Place the tip of the nozzle against the solder you wish to
remove.
5. When the solder melts, press the button [2] on the handle
and the solder will be absorbed.