Velleman VTDESOL3 - Manual (Page 3)

VTDESOL3
V. 01 – 12/06/2013 3 ©Velleman nv
5. Cleaning and nozzle replacement
1. Turn off the power and wait until the unit has completely cooled
before removing the solder waste or replacing the nozzle.
2. To clean the unit, push [1] the plunger slightly in the direction
of the button and remove it from the grip [2].
3. Remove the solder waste around the tip and inside the plunger.
4. To replace the nozzle, turn it anticlockwise with a pair of pliers
and remove from the handle.
Use this device with original accessories only. Velleman nv
cannot be held responsible in the event of damage or injury
resulting from (incorrect) use of this device.
For more info concerning this product and the latest version
of this manual, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.