Velleman WB023 User Manual
Page 4
WB023 - WB024
27/04/2011
©
Velleman nv
4
4. Features
• ultra slim tilting bracket (distance to wall only 46mm)
• universal mounting pattern
• for LCD/plasma TV
• built-in level for easy installation
• according to:
WB023: VESA 400x200
WB024: VESA 800x400
• comes with all necessary plugs and screws for assembly and mounting
5. Installation
Refer to the illustrations on pages 2 and 3 of this manual.
(1) Use the wall mounting bracket to determine and indicate the position of the mounting holes.
Use 6 screws, 3 on top and 3 at the bottom of the plate. The distance between the holes must be at
least 200mm and the outer holes must fall to the left and right of the middle of the plate. Make
sure to mount the plate horizontal using the built-in spirit level [X].
•
When mounting on a brick or concrete wall, drill holes (at least 60mm deep) at the
indicated positions. Insert the included anchors [E] and mount the wall mounting bracket
on the wall using the 6 included screws [D] and washers [H].
•
(2) When mounting on a wooden wall or wall support, drill holes size Ø3mm and at least
60mm deep at the indicated positions. Make sure all the holes are drilled in solid wood
and that they are blind holes. Mount the wall mounting bracket on the wall using the 6
included screws [D] and washers [H]. Do not use anchors.
(3) Mount the TV mounting bracket on the back of the TV as close as possible to the centre [a] and
aligned with the top of the TV-screen [b].Depending on the TV screen, use the correct bolts
[F], [I], [J],[K] or [M], together with the correct washers [C]. Make sure that the threaded
inserts of the TV are deep enough to tighten the bolts without damaging the TV. When
necessary (e.g. curved TV-back, bolt too long), use the included plastic spacers [H].
(4) Hook the TV with the TV rails [B] over the wall plate [A].
(5) Tighten the safety screws [F] at the bottom of the rail.
To set the viewing angle, release both knobs [Z], adjust the angle (0~10°) and re-tighten both
knobs [Z].
6. Technical specifications
WB023 WB024
LCD/plasma size
23"-37" / 58-94cm
37"-55" / 94-139cm
max. load
60kg / 132lbs
TV to wall
±46mm
Tilt -10°~0°
Use this device with original accessories only. Velleman nv cannot be held responsible in
the event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product and the latest version of this user manual, please visit our
website
www.velleman.eu
. The information in this manual is subject to change without
prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied, reproduced, translated or reduced
to any electronic medium or otherwise without the prior written consent of the copyright holder.