Velleman VDLPROM9 - Manual (Page 2)

VDLPROM9 VELLEMAN ® 2
ENGLISH
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its
lifecycle could harm the environment. Do not dispose of the unit (or batteries) as unsorted
municipal waste; it should be taken to a specialized company for recycling. This device
should be returned to your distributor or to a local recycling service. Respect the local
environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing VELLEMAN ® ! Please read the manual thoroughly before bringing this device
into service. If the device was damaged in transit, don't install or use it and contact your dealer. Refer
to the Velleman
®
Service and Quality Warranty on the final pages of this manual. Your
VDLPROM9 should contain a 20 W strobe, a mirror ball with fixation cone and built-in DC motor, a
PAR36 pin spot with mounting bracket and base, a PAR36 lamp, 4 colour filters and this manual.
2. Safety Instructions
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room
temperature.
• Parts of the VDLPROM9 fall under protection class II and are double insulated. Other parts fall
under protection class I. It is therefore essential that these parts be earthed. Have a qualified
person carry out the electric connection.
• Make sure that the available voltage equals the voltage stated in the specifications of this
manual.
• Do not crimp the power cord and protect it against damage.
• If the external flexible cord of the luminaire is damaged, it shall exclusively be replaced by the
manufacturer, his service agent or a similar qualified person in order to avoid a hazard.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord
by the plug only.
• There may be some smoke or a particular smell when the device is activated for the first time.
This is normal and any smoke or smell will gradually disappear.
• Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.
• Keep the device away from splashing and dripping liquids. Never put objects filled with liquid on
top of the device.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• Keep the device away from children and unauthorised users.
Be very careful during the installation: touching live wires can cause life-threatening
electroshocks.
Do not touch the device during operation as the housing heats up.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.