Velleman WS8707 - Manual (Page 5)

WS8707 Rev. 02
28.12.2012 ©Velleman nv
5
S1 sensor display S4 channel selector
S2 suspension S5 °C/°F selector
S3 test button S6 battery compartment
6. Settings
Refer to the illustrations on page 2 of this manual.
•
Insert batteries in the battery compartment at the back of the weather
station. Follow the polarity as indicated in the battery compartment (see
§9).
Setting the date and time
•
To switch between 12h and 24h format, press UP [C].
• Press and hold SET [I] for ±2s. The year indication starts flashing [4].
• Press the UP [C] or DOWN [B] to set the year, press SET [D] to confirm.
The month indication [1] starts flashing.
• Use UP [C] or DOWN [B] to successively set the month [1], date [1],
day language [2] (EN= English, IT = Italian, FR = French, NE = Dutch,
ES = Spanish, DA = Danish, GE= German), hour [4], minutes [4] and
time zone [4]. Confirm each setting with the SET button [D].
Notes:
•
press and hold UP [C] or DOWN [B] for fast progress
•
day of the week and moon phase change automatically depending on
the set date and time.
•
the display will return to normal operation after ±7s of inactivity
Alarm setting
• Press and hold ALARM [E] for ±2s. The alarm time is displayed [4] and
the hour indication is flashing.
•
Use UP [C] or DOWN [B] to successively set the hour and minutes.
Confirm each setting with the ALARM button [E].
Remote sensor
•
Slide the back of the remote sensor open (slide down) and make sure
batteries are present inside the remote sensor (see §9).
• Set the channel selector [S4] to the desired channel (1~3). The channel
is indicated on the LCD [S1].
Note: when multiple sensors are used they must be set to different
channels.
•
Set the same channel on the clock using the channel selector [F]. The
channel is shown on the LCD [13].
•
Press the test button [S3] to test the link between the sensor and the
clock. When everything works fine, a link indicator
[14] lights up
briefly on the LCD and the clock will beep once.
•
Press the °C/°F selector [S5] to set the temperature scale on the remote
LCD [S1] to °C or °F.
Note: this setting is only applicable for the temperature indication on the
remote sensor itself, not on the clock.
• Close the back of the sensor.