Velleman VSCP1 USER MANUAL - Manual

VSCP1-VISP1 VELLEMAN 1
VISP1
PAN/TILT UNIT
USER MANUAL
1. INSTALLATION
The unit is intended to be mounted on a Wall Mount. Installation of the pan
and tilt drive to the wall mount requires a stainless steel 1/4-20 screw
supplied with the wall mount. Note the ribs on the underside of the unit base
engage slots in the mount. This allows positioning of the unit in any of four
directions with respect to the wall mount. Secure unit to the wall mount using
screw from underside of wall mount into unit and tighten.
2. WIRING OF UNIT
Fabricate the interconnecting cable in accordance with Figure 1. for proper
operation.
Figure 1
Cable Assembly Diagram
3. INVERTED MOUNTING
When the unit is mounted in the inverted position, the left-right directions are
reversed for manual operation. This must be corrected when wiring the cable
between control unit and the pan and tilt drive. Simply reverse leads going to
terminals 3 and 4.
4. ADJUSTING LIMIT STOPS
After cable is installed and unit has been mounted, proceed as follow :
1. Plug control unit into AC 24V source. Be sure auto switch is in the OFF
position.
POWER (red)
COMMON (black)
TILT DOWN (yellow)
TILT UP (blue)
PAN RIGHT (green)
PAN LEFT (white)