Velleman VSCP1 USER MANUAL - Manual (Page 2)

VSCP1-VISP1 VELLEMAN 2
2. To adjust pan limit stops (see Figure 2), loosen screws securing both
stops (1) and (3) to unit. Slide stops around unit to desired locations and
secure by tightening screws.
3. To adjust tilt limit stops (see Figure 2) located in each end plate, remove
two screws securing each end cap to unit. Loosen and adjust tilt limit
stop screws for desired tilt limit position. Tighten limit stop screws and
reinstall each end caps to unit and secure with two screws.
Figure 2
Limit Stop Adjustment and Camera Mounting Plate