Velleman VDPC145 - Manual (Page 7)

VDPC145_v2 VELLEMAN 7
f) Clearing all Chases
1. Press ▼ and AUTO/DEL simultaneously while deactivating the device.
2. Turn the device back on.
Running Scenes
The device is in RUN mode when it is turned on. Hold the PROGRAM button for 2 seconds to enter the PROGRAM
mode. Subsequently, the device automatically switches to the BLACKOUT mode. Press the BLACKOUT button to
enter the RUN mode. Only those scenes programmed into a bank can be run.
a) Manual Run
1. Make sure AUTO TRIGGER and MUSIC TRIGGER are off.
2. Select a bank with ▲ or ▼ or through MIDI signals.
3. Press the desired SCENE button.
b) Auto Run
1. Press AUTO/DEL. The AUTO TRIGGER LED comes on.
2. Press TAPSYNC/DISPLAY. Press it again after an interval of your choice. The interval between the two presses
is the assigned speed of AUTO RUN (max. 10 min.). If you press more than twice, only the last two presses are
taken into account.
3. Select a bank with ▲ or ▼ or through MIDI signals.
4. Press AUTO/DEL again to leave the AUTO RUN mode.
c) Music Run
1. Press MUSIC/BANKCOPY. The MUSIC TRIGGER LED is lit.
2. Select a bank with ▲ or ▼ or through MIDI signals.
3. Press MUSIC/BANKCOPY again to leave the MUSIC RUN mode.
d) Midi Run
The scenes from a bank are selected through the MIDI input whenever the device is in the MANUAL RUN, AUTO
RUN or MUSIC RUN mode.
e) Chase Run
To use a chase run you have to make programmes first. A chase run can be activated via the MANUAL RUN, AUTO
RUN, MUSIC RUN and MIDI RUN modes.
Select the desired chase with the CHASE button. The selected chase is displayed on the LCD.
f) Fade Time Control
Adjust the fade time with the slider.