Velleman CAMIP16 User manual - Manual (Page 6)

CAMIP16
V. 01 – 13/06/2013 6 ©Velleman nv
DO NOT use this product to violate privacy laws or perform other illegal
activities.
4. Overview
Refer to the illustrations on page 2 of this manual.
1 lens 16 8P8C network cable
2 sun shield 17 8P8C network cable
3 bracket 18 power
4 position bolt 19 PC
5 bracket screw holes 20 non-PoE router/hub
6 joint 21 8P8C network cable
7 camera screw holes 22 PoE injector
8 camera front cover 23 8P8C network cable
9 focal length screw 24 power
10 focus screw 25 NVR
11 desiccant 26 LAN SWITCH connector
12 sun shield installation 27 8P8C network cable
13 microSD card 28 router/hub
14 PC 29 8P8C network cable
15 PoE router/hub 30 cameras
5. Installation
1. Choose a location for the camera, keeping following guidelines in mind:
o Do not install the camera in locations where extremely high or low
temperatures or excessive vibrations may occur.
o Avoid mounting the camera near high electro-magnetic fields.
o Do not aim the camera at the sun or other extremely bright objects
or reflections (e.g. metal doors).
2. Use the mounting bracket [3] to determine the location of the
mounting holes. Drill the holes and secure the bracket using
3 screws [5].
3. Remove the joint [6] from the bracket.
4. Connect the joint to the back of the camera.
Note: There are two screw holes [7] for the joint on the back of the
camera. Choose the one that best suits your installation location.
5. Re-attach the joint (with the camera) to the mounting bracket.
6. Point the camera towards the field of interest and tighten the position
bolt [4].