Velleman AS1N User Manual
Page 2
Page 2 / 2
Pictures:
AS1N:
AS4:
AS5:
AS8:
Guidance:
Matting materials have a tendency to shrink slightly when first unrolled. In applications where
length is critical, allow the material to relax for at least 4 hours before cutting to size. Matting
can be trimmed with a sharp knife.
Note that contact between the matting surface and any acid or alkali solvent will result in degradation of
the antistatic performance. If cleaning is required, the matting may be wiped with a cloth coated in a
neutral solution
Other information:
The above information is believed to be correct but does not purport to be all inclusive and shall be
used only as a guide.
The information in this data sheet was obtained from sources which we believe are reliable.
However, the information is provided without any warranty, express or implied, regarding its
correctness.
The conditions or methods of handing, storage, use or disposal of the product are beyond our control
and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and
expressly disclaim liability for loss, damage or expense arising out of - or in any way connected with
the handling, storage, use or disposal of the product. This data sheet was prepared - and is to be
used only with this product.
Velleman NV - Legen Heirweg 33 B-9890 Gavere Belgium - www.velleman.eu