Velleman CCTVPROM15 - Manual (Page 7)

CCTVPROM15
V. 1.0 – 07/12/2012 7 ©Velleman nv
7. Preliminary settings
• Make sure the connected cameras are powered on.
• Set the power switch of the DVR at the back of the device to ON.
It takes about 15 to 30 seconds to start up.
Menu overview
Press the MENU button and enter the password to go into the menu list.
Note: default admin password is “0000” (4 times zero).
QUICK START GENERAL - TIME SETUP
DATE SETUP DATE INFO - DAYLIGHT
SYSTEM ACCOUNT TOOLS - SYSTEM INFO – BACKUP DATA – BACKUP LOG
EVENT
INFORMATION QUICK SEARCH - EVENT SEARCH - HDD INFO - EVENT LOG – BACKUP LIST
ADVANCED
CONFIG CAMERA – DETECTION – ALERT – NETWORK – DISPLAY – RECORD –
DEVICES NOTIFY
SCHEDULE
SETTING RECORD – DETECTION – ALARM
Refer to the full user manual on the included CD-ROM for more details.
Setting date and time
Before using the DVR the time and date should be set to get a valid time stamp.
1. Press the MENU button and enter the admin password to go into the menu list.
2. Select the QUICK START menu item.
3. Use the navigation button to move to the TIME SETUP menu item. Select it to set date and time.
Note: once recording started, do not change date or time as this will make it very difficult to find back the
recorded files.
Note: when using the DVR for the first time and the correct time is set, leave it on for at least 48 hours.
Password setting
1. Press the MENU button and enter the password to go into the menu list.
2. Select the SYSTEM menu item.
3. Go to TOOLS. Select ADMIN PASSWORD (or OPERATOR PASSWORD) and press the ENTER button to set the
password.
Note: an operator can not access the main menu, only the quick menu bar (see below).
4. Press the cursor up ( ) or down ( ) button to select the value of the first number and press enter to
save and go to the next character, or use the mouse to select the desired value. Repeat this for all four
password numbers.
Note: default admin password is 0000 (4 times zero).