Velleman CU2200 - Manual (Page 6)

CU2200 v 3-02
26.10.2012 © Velleman nv 6
c. System Information Report
• Default Setting
• System Parameters RESET
• System Version Check (hardware version CU2200)
• Return Message
• System Parameters Report
• Manual Health Report
• Configure the CU2200 through the command text sent from your mobile phone. Upon reception and
processing, the unit will send a confirmation message to your mobile phone. If the command is incorrect,
the unit will reply SMS format is error!
a. System Setup
• New Password Setup
Command: PWD:XXXX,NEWPWD:YYYY%
XXXX Current password
YYYY New password (4 digits)
Example:
PWD:1234,NEWPWD:2222%
Default password: 1234
New password: 2222
• Manual Health Reporting
Command: PWD:XXXX,STATUS%
[SMS message received]
ST:XXX;T:2005/01/28/13:00;V:XXXX;A1:0000;A2:0000;K1:X;K2:X;K3:X;K4:X;K5:X;K6:X;K7:X;K8:
X;OUT1:Y;OUT2:Y;OUT3:Y;#
Example:
ST:002;T:2005/01/28/13:00;V:8.15;A1:0000;A2:0000;K1:X;K2:X;K3:X;K4:1;K5:1;K6:X;K7:X;K8
:X;OUT1:1;OUT2:1;OUT3:1;#
ST Unit serial number XXX ASCII code
T Unit internal clock XXXX Year/month/day/time
V Operating voltage XXXX
K1 Alarm channel 1
K1:0 means closed
K1:1 means open
K1 ~ 8 Alarm channel 1 ~ 8
OUT1 Relay output 1
OUT1:0 means open
OUT1:1 means closed
OUT1 ~ 3 Relay output 1 ~ 3 (outputs 2 and 3 are
displayed but not available)
• Serial Number Setup
Command: PWD:XXXX,SN:YYY%
XXXX Password
YYYY
Serial number (0-999)
Example:
PWD:1234,SN:268%
Password: 1234 (default)
Serial number set into the unit: 268 (default: 000)
• Control Centre Number & Health Reporting Schedule Setup
These two values are configured by one single command.
(1) The control centre number is the phone number receiving the periodic report and regular report.
Besides the periodic report on schedule (command 5: power-up message), report of any command will
be sent to this number in addition to the mobile phone number sending the command. Maximum 2
control centres can be defined.
Command: PWD:XXXX,CTRZ:YYYYYYYYYYY,MM#%
XXXX Password
Z
Control centre number (max. 2 centres)
1 means 1 st centre number
2 means 2 nd centre number
YYYYYYYYY Phone number in control centre
MM Period code of automatic scheduled health report
Example:
PWD:1234,CTR1:123456789,04#%
Password: 1234
Reporting health status every hour (refer to the reference table below)
(2) The periodic health report and any command from another mobile phone will be reported to the
first control centre with number 123456789.