Velleman DB1 - Manual (Page 2)

DB1
VELLEMAN 1
DB1 – WIRELESS REMOTE DOOR CHIME
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the DB1! Read the manual carefully before bringing this user-friendly door chime into service.
2. Features
•
the DB1 can be used as a doorbell, a remote pager or a panic switch
•
the DB1 has a range of approximately 200ft (= 60m)
•
easy installation: no wiring or AC power required
•
uses a coded radio signal to prevent the kind of false triggering traditionally caused by other devices
•
the jumpers make it easy to select the code and the ringing tone
•
meets the highest quality standards in telecommunications
•
two bell chimes: ding-dong and Westminster
3. Installation
a) Transmitter (see figure below)
•
insert a 12V battery (GP23GA) and close the cover
•
select a code, choose a suitable mounting location and attach the device to the wall with the double-sided tape
b) Receiver (see figure below)
•
insert three C-batteries
•
use the same code for transmitter and receiver. You can place the latter in the dining room, the study, the
bedroom, etc.
•
the user can hang the device on the 2 included screws.
Move the jumpers of both transmitter and receiver if
an other door chime system interferes. The jumpers
for the receiver should be placed in the same position
as those for the transmitter.
transmitter
receiver
(chime)
Note that jumpers 7 & 8 of the transmitter are used to
select the ringing tone.