Velleman HAM263D - Manual (Page 15)

HAM263D
03 (15/11/2013) VELLEMAN 15
- If you have forgotten the master code, you can reset it. See b. Reset master code.
• The master code is the authorization code for setting the system in programming mode.
• It can consist of 4 to 6 digits.
• After entering a new master code, the old one is erased.
• Format:
01yyyyyy#
01
master code
yyyyyy = 4 to 6 digits
# =
validation
e. Record a user code
Notes: user code
- Any user code must be different from the master code.
- It is recommended to program a different code for every user.
• It can consist of 4 to 6 digits.
• After entering a new user code, the old one is replaced.
• To remove a user code, key in the location, immediately followed by #.
• Format:
XXyyyyyy#
XX =
11 USER CODE 1 for arm/disarm control of part. 1
12 USER CODE 2 for arm/disarm control of part. 2
13 USER CODE 3 for arm/disarm control of the
whole system (partition 1 and 2)
yyyyyy = 4 to 6 digits
# = validation
f. Memorize frequently bypassed zones (“HOME” mode)
• HOME mode is only available for use with USER CODE 3 (whole system). However, partitions
can be bypassed by bypassing the zones within the partition one by one.
• Zone 8 (24 hour zone) is excluded from use in HOME mode
• Format:
HOMEyyyyyy#
HOME
Press HOME button on keypad
yyyyyy = List of zones to be enabled, sequential e.g. 245 to
bypass zones 2, 4 and 5
# = validation
• To use the home mode, simply type USER CODE 3, and ; all programmed zones will
automatically be bypassed.
g. Keypad audible notification set-up
• Some audible notification can be passed on to the keypad. This is the case for the exit and entry
delay, after an alarm condition and for each key button press.
• Alarm conditions concerning battery low or AC power failure conditions are always ON.
• Passing these notifications through to the keypad will not affect the beep settings on the master
control unit.
• Note that confirmation beeps from the -button and -button are always enabled.
14yyyy#
14
master code
yyyy = 4 digits: 0=beep disabled, 1=beep enabled (default)
digit 1 Beep for exit delay
digit 2 Beep for entry delay
digit 3 Beep after alarm condition
digit 4 Beep after each key button press
# = validation