Velleman DVRSD1 - Manual (Page 4)

DVRSD1
22.09.2011 © Velleman nv 4
1 DC 12V in 10 MODE button
2 DIN connector (see below) 11 DISP button
3 Video 1 input 12 SHOT button
4 Video 2 input 13 ZOOM button
5 Video output connector 14 UP button
6 power indicator 15 MENU/OK button
7 detect indicator 16 LEFT button
8 SD card slot 17 RIGHT button
9 power ON/OFF switch 18 DOWN button
6. Installation
Refer to the illustrations on page 2 of this manual.
•
Insert a suitable SD card into the card slot [8]. Make sure the overwrite protection is not enabled.
• Connect the cameras (not incl.) to the video inputs [3, 4]. It is possible to power the cameras via
the DIN connector. Insert the DIN cable into the connector [2] and connect one of the red power
plugs to the camera.
Note: max. Current is 600mA through both plugs, so either connect two cameras each requiring
max. 300mA or one camera that draws max. 600 mA.
• When the cameras support sound, connect the appropriate audio inputs via the DIN cable: connect
audio from video 1 to the yellow RCA, from camera 2 to the red RCA.
• Connect a monitor (not incl.) to the video output connector [5]. When applicable, also connect the
audio out connector from the DIN cable (white RCA) to the monitor. The monitor needs its own
power supply.
• Connect the included power adaptor to the 12Vdc input [1] and plug the adaptor into a suitable
mains outlet.
• Switch the power switch [9] to the ON-position. The power indicator [6] lights up.
7. Menu overview
• Press the MENU button [15] to enter the on-screen menu.
• Use the UP [14], DOWN [18], LEFT [16] and RIGHT [17] buttons to navigate through the menus.
• Press OK/SHOT [15] to enter a submenu or accept a setting.
Manual capture
Photo 1 capture 1 picture
Photo 3 capture 3 pictures
Movie start/stop recording 1 AVI video
Movie clip start/stop recording short AVI videos (1 minute)
EXIT
Auto capture
Auto capture
On switch auto-capture function on
Off switch auto-capture function off
EXIT
Master capture
Photo 1 auto-capture 1 picture
Photo 3 auto-capture 3 pictures
Movie 5s auto-capture 5s movie
Movie 10s auto-capture 10s movie
EXIT
Movie prerecord
Movie 5s set pre-record time to 5s
Movie 10s set pre-record time to 10s
Off no pre-recording
EXIT
File overwrite setting
On overwrite files when SD card is full
Off stop when SD card is full
EXIT
EXIT