Velleman CWS1 - Manual (Page 6)

CWS1
19.02.2010 ©Velleman nv 6
• Press and hold the ALARM-button [D] for ±5s. The display shows the
alarm time; the hours are flashing.
• To change the setting, use the UP-[E] or DOWN-[F] button.
• Press the ALARM-button [D] to confirm and move to the minutes-setting.
• After setting the alarm minutes, press the ALARM-button [D] to confirm
and exit to normal display.
• If no key is pressed within 8s the clock returns to normal operation.
8. Operation
Alarm handling
• To enable the alarm, press the ALARM-button [D] shortly. The alarm-icon
appears. To disable it, press the ALARM-button [D] again.
• When the set time is reached, the alarm will sound. Format:
0~10s: 1 beep per second
11~20s: 2 beeps per second
21~30s: 4 beeps per second
31~120s: continuous beep.
• To go into snooze mode, press the SNOOZE-button [A]. The alarm is
postponed for ±5 minutes and the snooze-icon appears.
• Pressing any other button will stop and exit the alarm.
Weather forecast [4]
• The weather icon shows a forecast of the weather for the next 24h.
• There are 4 icons:
sun sun/clouds
clouds
rain
• Place the weather station in a natural ventilated area (e.g. not in a room
with air-conditioning) to get more accurate results.
Temperature display [5]
• The temperature range is 0~50°C (32~122°F).
• To switch between °C and °F display, press the CF button [F] shortly.
• The trend indicator is based on the difference between a recorded
temperature and the current temperature. When the current temperature
is at least 1°C higher than the recorded, the arrow will point up and the
current temperature becomes the recorded. If the temperature is at least
1°C lower than the recorded value, the arrow will point down and the
current temperature becomes the recorded. In all other cases, the arrow
will be flat.
Note: the recorded temperature is set to the current temperature at
start-up or reset of the weather station.