Velleman GASMT1 User Manual
Page 3
GASMT1
07.01.2011 3
©Velleman
nv
3. General Guidelines
Refer to the Velleman
®
Service and Quality Warranty on the final pages of
this manual.
•
Protect this device from shocks and abuse. Avoid brute force when
operating the device.
•
Protect the device against extreme heat and dust.
•
Indoor use only. Keep this device away from rain, moisture, splashing and
dripping liquids.
•
Familiarise yourself with the functions of the device before actually using
it.
•
All modifications of the device are forbidden for safety reasons. Damage
caused by user modifications to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an
unauthorised way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not
covered by the warranty and the dealer will not accept responsibility for
any ensuing defects or problems.
4. Parts of the device
Refer to the illustration on page 1 of this manual.
1 Burner
5 "Continuous" switch
2 Air adjustment ring
6 Gas tank
3 Gas adjustment valve
7 Refilling valve
4 Ignition push button with safety lock
8 Base
5. Use
•
Release the safety lock under the ignition button (#4) by pulling it down
until it clicks.
•
Set the air adjustment ring (#2) and the gas adjustment valve (#3) halfway
between open (+) and closed (‐).
•
Press the ignition button (#4) to ignite the GASMT1. You can keep the
ignition button pressed to hold the flame, or lock the ignition button with
the "continuous" button (#5).
•
Adjust the flame by regulating the gas valve (#3) and the air ring (#2).
•
When finished, press and release the ignition button (#4) to extinguish the
flame.
6. Refilling the gas tank
1. Make sure the device is not burning and the safety lock (#4) is engaged.
2. Close all taps, valves and adjustment knobs of the device before refilling it.
3. Refill in a well‐ventilated area.
4. Refill with decent quality butane gas only.
5. Place the torch upside down.
6. Insert the nozzle of the butane canister into the torch refilling valve.
7. Press the canister down until the gas starts to flow.