Alpine INA-W910R - Manual (Page 73)

INA-W910R Navigation Software Owner’s Manual 73
Gives a quick but fuel efficient route based on the fuel consumption
data given in Green Routing settings (page 73). Travel cost and CO
2
emission calculations are estimations only. They cannot take
elevations, curves and traffic conditions into account.
Results in a route with fewer turns and no difficult manoeuvres. With
this option, you can make your software to take, for example, the
motorway instead of a series of smaller roads or streets.
When selecting the Route Planning Method, tap the button at the bottom of the screen to
adjust the Green Routing setting:
Enter the average consumption of your vehicle when used in built-up
areas. The unit for consumption can be set in Regional Settings.
Enter the average consumption of your vehicle when used on
highways. The unit for consumption can be set in Regional Settings.
Select the engine and fuel type of your vehicle. This helps in estimating
the CO
2
emission.
Enter the average fuel price for travel cost calculation. The currency
can be set in Regional Settings.
If the selected routing method is not Green, you can have your route
compared to the best green alternative on the screen when confirming
the route. If this alternative is much better than the selected method,
you can quickly switch to Green mode.
4.3.5 Green routing settings
These settings determine how Green routes will be calculated. They are also used to display
the cost and CO
2
emission of routes.
Button Description
Enter the average consumption of your vehicle when used in built-up
areas. If necessary, tap and select
to change the measurement unit.
Enter the average consumption of your vehicle when used on
highways. If necessary, tap and select
to change the measurement unit.