ACP RFS518TS Owner's Manual - Manual (Page 11)

11
User Options
(Electronic Control)
Changing user options
Options such as single or double key programming, beep volume, and
maximum cooking time can be changed to suit individual preferences.
To change options:
1. Open oven door.
• If door is closed or STOP/RESET key is pressed before programming is
complete, changes are discarded and microwave exits programming
mode.
2. Press and hold key 2 for approximately 5 seconds.
• This begins options mode.
• Microwave will beep and 0P: -- displays. Microwave is now in
programming mode.
3. Press number key that controls option to be changed.
• See table below for options.
• Current option will display.
4. Press number key again to change the option.
• Each time key is pressed, option will change.
• Match number code displayed with descriptions for desired option.
5. Press START key to save changes.
• 0P: -- shows in display.
• To change additional options, repeat steps 3 and 4.
• Changes appear after door is closed or STOP/RESET pad is pressed.
Didn’t like an option?
Factory settings are marked in bold.
To change the oven back to the
factory setting, simply select the
option that is marked in bold.
My changes weren’t
saved.
In order for any changes to
be saved, the START key
must be pressed after selecting an
option. Shutting the oven door or
pressing the STOP/RESET key will
not save changes.
Numbered Keys Display Options (Factory Settings in Bold)
1
End of Cycle Beep
OP:10
OP:11
OP:12 3 second continuous beep.
Continuous beep until door is opened.
5 beeps bursts until door is opened.
2
Key Beep Volume
OP:20
OP:21
OP:22
OP:23 Eliminates beep.
Sets volume to low.
Sets volume to medium.
Sets volume to high.
3
Key Beep
OP:30
OP:31 Prevents beep when key is pressed.
Allows beep when key is pressed.
4
Active Display
OP:40
OP:41
OP:42
OP:43 15 seconds after oven door is opened, keyboard disabled.
30 seconds after oven door is opened, keyboard disabled.
1 minute after oven door is opened, keyboard disabled.
2 minutes after oven door is opened, keyboard disabled.
5
On-the-Fly Cooking
OP:50
OP:51 Prevents different pre-programmed keys to be activated during cooking.
6
Reset to Ready Mode
OP:60
OP:61
Opening oven door does not reset oven back to ready mode.
7
Maximum Heating Time
OP:70
OP:71 Allows 60 minutes of heating time.
Allows 10 minutes of heating time.
8
Manual Operation
OP:80
OP:81 Allows use of preprogrammed keys only.
Allows use of manual time entry and preprogrammed keys.
9
Double Digit Operation
OP:90
OP:91 Allows 10 (0-9) preprogrammed keys.
Allows 100 (00-99) preprogrammed keys.
Allows different pre-programmed keys to be activated during cooking.
Opening oven door resets oven back to ready mode.
0
Clean Filter Message
OP:00
OP:01
OP:02
OP:03 Oven will not display Clean Filter
Oven will display Clean Filter every seven (7) days
Oven will display Clean Filter every thirty (30) days
Oven will display Clean Filter every ninety (90) days