Dial operation, So...how do i use it, Style 3 – ACP RFS518TS Owner's Manual User Manual
Page 14: Dial option is available on some 50 hz models only, Dial), Heating, Interrupting operation, Changing time and power/canceling mistakes
14
Dial Operation
Dial option is available on some 50 Hz models only.
Oven Wall Clearances
A—For North American (UL/CSA) models, allow
at least 2” (5.1 cm) of clearance around top
of oven. For International (50 Hz) models,
allow at least 12” (30 cm) of clearance
around top of oven. Proper air flow around
oven cools electrical components. With
restricted air flow, oven may not operate
properly and life of electrical parts is
reduced.
B—Allow at least 2” (5.1 cm) between air
discharge on back of oven and back wall.
C—Allow at least 2” (5.1 cm) of clearance around
sides of oven.
B
A
C
The switching operation of this
microwave oven can cause voltage
fluctuations on the supply line.
The operation of this oven under
unfavorable voltage supply conditions
can have adverse effects. This device
is intended for the connection to a
power supply system with a maximum
permissible system impedance Zmax
of
0.2 Ohms at the interface point of
the user’s supply. The user has to
ensure that this device is connected
only to a power supply system
which fulfills the requirement above.
If necessary, the user can ask the
public power supply company for the
system impedance at the interface
point.
No metal pans
DO NOT power spray
So...how do I use it?
(Dial)
100%
15%
30%
75%
Heating
1. Open oven door, place food in oven, and close oven door.
2. Turn the power level knob to desired power level.
• Power level can be set at Hold (15%) Defrost (30%), Medium (50%),
Med. High (70%), or High power (100%).
3. Turn time entry knob clockwise until desired time displays.
• Cooking time can be set up to 10 minutes.
• If turning the timer knob for less than 2 minutes, turn it past 2 minutes
and then back to the desired time.
4. Oven begins operation and time counts down.
5. When cooking time elapses, microwave energy stops and oven signal
sounds.
Interrupting Operation
Open oven door to interrupt operation or turn time entry knob
counterclockwise to “0”. To resume microwave oven operation, close oven
door.
If time was changed to “0”, time will need to be reset.
Changing Time and Power/Canceling
Mistakes
Cooking time and power level can be changed at any time while the oven is
operating. Turn knob(s) to desired new setting. To set cooking time to zero,
turn time entry knob counterclockwise to “0”.
STYLE 3