ACP RC22S2 Owner's Manual - Manual (Page 12)

Care and Cleaning
To avoid risk of burns or
electrical shock:
• disconnect electrical supply to
oven before changing light bulb.
• before replacing light bulb make
sure oven and bulb are cool.
• do not operate oven without
bulb and access cover in place.
To avoid risk of personal injury,
wear gloves to protect hands
from accidental bulb breakage.
To avoid risk of product damage,
do not operate oven without
splatter shield in place. Arcing
will damage oven cavity and
antenna when operated without
shield in place.
Cleaning Splatter Shield
Splatter shield keeps top of microwave oven cavity and antenna from
becoming soiled. Clean soil from shield with damp cloth or clean with mild
detergent and water. Remove splatter shield for easy cleaning.
1. Unplug oven before removing splatter shield to stop antenna from
rotating.
2. Place fingers on front of shield, push forward, and down.
• When removing and replacing splatter shield, be careful not to bend
antenna.
Removing Splatter Shield
3. Wash shield in hot, soapy water. Rinse and dry thoroughly.
• Do not wash splatter shield in dishwasher.
• Do not use abrasive cleaners.
4. Reinstall splatter shield by fitting tabs into slots at top of oven cavity
back. Lift and press front of shield until shield snaps into place.
1. Disconnect electrical supply.
2. Remove screw from access cover
on top left wall of oven exterior.
3. While wearing protective
gloves, unscrew the light bulb
counterclockwise.
4. Replace light bulb with 230-volt,
40-watt appliance bulb.
• Do not over tighten bulb or it
may be difficult to remove later.
5. Replace access cover before use.
6. Reconnect power supply.
Replacing Oven Light
12