Daystar KJ71031 User Manual

Page 2

background image

Thank you for choosing Daystar Products

Daystar recommends a certified technician install this system . In addition
to these instruction , professional knowledge of disassemble/reassembly
procedures as well as post instructions checks must be known. Attempts to
install this system without this knowledge and expertise may jeopardize the
integrity and/or operating of the vehicle.

Please read all the instructions before beginning the installation. Check the
kit hardware against the parts list. Be sure you have all the needed parts and
understand where they go. If anything is missing , do not proceed with the
installation, Call Daystar Products to obtain needed items.

Product Use Information

As a general rule, the taller a vehicle is the easier it will roll. We strongly
recommend , because of rollover possibility, that Seat belts and shoulder
harness be worn at all times. Avoid situations where a side rollover may

Braking performance and capabilities are decreased when significantly
large/heaver tires and wheels are used. Take this into consideration while
driving, Also , speedometer recalibration is necessary when larger tires are

Do no add, alter, or fabricate any factory or after-market parts which in-
crease vehicle height over the intended height of the Daystar Product pur-
chased. Mixing component brands, lifts, and/or combining body lift with
suspension lift voids all warranties. Daystar makes no claims regarding
lifting devices and excludes any and all implied claims. We will not be

responsible for any products that is altered


Notice to Dealer and Vehicle Owner

Any vehicle equipped with any Daystar Product must have the “Warning to
diver” decal installed on the sun visor or dash. The decal is to act a constant
reminder for whoever is operating the vehicle of its unique handling charac-
teristics. INSTALLING DEALER— Its is your responsibility to install the
warning decal and forward these instructions on too the vehicle owner for
review and to be kept in the vehicle for service life.

After installation occurs, a qualified alignment facility is required to align
the vehicle to factory specs.

Installation steps

1. Clean the top of the dash panel.
2. Set the panel on top of the dash.
3. Using a Phillips screw driver, screw in the 2 self taping screws.