Rough Country 209 - Manual (Page 10)

54. Install the supplied brake line relocation bracket on the upper
control arm mount with the stock hardware. Slightly pull down
on the brake line assembly and reinstall on the drop bracket
with the supplied 5/16” x 3/4” bolts, nuts /washers using a 7/16
wrench. See Photo 36. Reconnect the ABS wire that was
disconnected in Step 6.
55. Remove the ABS wire from the brake line clip and remove the
brake line from the bracket using a flat head screw driver as
shown in Photo 37 and trim as shown in Photo 38. Reinstall
the modified bracket on the stock control arm with the stock
hardware and reinstall the ABS wire in the clip.
56. If the optional kicker bars were purchased with this kit, install
at this time per the instructions included with that kit.
57. Reinstall the factory upper skid plate with the factory hardware.
58. Install the tires and wheels. Jack up the front of the vehicle and
remove the jack stands.
59. Lower the vehicle to the ground.
Photo 36
Photo 37 Photo 38