Rough Country 794 - Manual (Page 3)

PHOTO 11 PHOTO 12
7. Use two of the supplied 7/16” x 1” bolts and washers to attach the skid plate to the bracket. Tighten with a 5/8” socket. Tighten
the factory bolt holding the bracket with a 18mm socket. See Photo 7.
8. Remove the rear inner factory bolt using a 18mm socket. See Photo 8.
9. Locate the correct mounting bracket and insert factory bolt in the top of the bracket. Hand tighten. Use two of the supplied 7/16”
x 1” bolts and washers to attach the skid plate to the bracket. Tighten with a 5/8” socket. Tighten the factory bolt holding the
bracket with a 18mm socket. See Photo 9.
10. Remove the rear outside factory bolt using a 18mm socket. See Photo 10.
11. Locate the rear outside mounting bracket and insert factory bolt in the top of the bracket. Hand tighten. See Photo 11.
12. Place the flag nut on the back side of the skid plate and insert the two supplied 7/16” x 1” bolts and washers. See Photo 11 &
12. Tighten with a 5/8” socket. Tighten the factory bolt holding the bracket with a 18mm socket.
PHOTO 9 PHOTO 10
PHOTO 7
PHOTO 8