Rough Country PERF694 - Manual (Page 5)

12. Secure the bracket as shown in Photo 10 with the sup-
plied 1/2” x 1 1/4” hardware. Tighten using a 3/4” wrench
& socket.
13. Attach the brake line bracket to the location on the frame
where the factory bracket was attached. Tighten using a
10mm wrench and stock hardware. Secure the factory
bracket to the bottom hole of the relocation bracket using
a 7/16 wrench and the supplied .250-20 x 1” bolts, wash-
ers, and nuts. See PHOTO 11.
14. Install the rear Rough Country Performance 2.2 shock in
the factory location using the factory hardware. Tighten
the upper mount using a 16mm wrench and a 18mm
wrench for the lower.
15. Reinstall the rear tires/wheels and tighten to factory speci-
fications. Lower the vehicle to the ground.
16. After the vehicle is on the ground, install the stock track rod in the lower hole of the new track rod bracket with the
stock hardware. See Photo 12. It may be necessary to pull the axle over to the passenger side to align the hole in
the bracket with the track rod bushing.
17. Tighten all track rod hardware using a 3/4”, 21mm & 22mm sockets/wrench.
Photo 10
Install the 1/2” x 1 1/4” bolt
Photo 12
Install the track bar in the new bracket
Photo 11